CUBEiT! removes pop-up heads from in-floor sytems
News
April 14, 2021
CUBEiT! removes pop-up heads from in-floor sytems

Tampa Bay Pool Tool Makers PoolPal USA and Multi-Tork Pool Tools have collaborated on a universal pool floor pop-up head removal tool. The six sides of CUBEiT! have alignment pins for virtually every brand of pop-up floor cleaning system in the industry. On the pool deck, connect any standard pool pole to the CUBEiT! channel connector with the threaded bolt and wing nut and insert the channel connector’s 3/8” drive bit into the CUBEiT! 3/8” drive hole opposite the removal pin side. In the water, insert the CUBEiT! alignment pins directly into the floor head. For hard to remove heads, insert a screwdriver through the channel connector’s two 3/8” holes for additional torque.

Contact: PoolPal USA (877) 825-7665; Multi-Tork Pool Tools (888) 929.7818 Email: info@poolpalusa.com, pwlshrk757@msn, Visit online at www.poolpalusa and www.muIti-tork.com

LATEST NEWS
Local CA agency leads emission policy
Will California swimming pool heater energy standardschangeregulationsinotherstates?
March 31, 2026
By Marcelle Dibrell With federal policy stepping back, California regulations are driving the future of gas pool heaters. The future of gas-fired pool...
March 31, 2026
If you’ve ever wondered whether one voice can truly make a difference in Washington, this experience answers that question. From April 28–30, 2026, PH...
March 31, 2026
“Let’s continue to send young adults to college and trade schools.” That’s the guiding motto of the Ralph A. Kerber Memorial Foundation — a scholarshi...
Fantastic time at the Southwest Show
March 31, 2026
The 2026 Southwest Pool & Spa Show, held February 15–19 in San Antonio, Texas, delivered a full week of education, exhibits, and industry networking, ...
Swim season comes early for snakes
March 31, 2026
A rattlesnake found struggling in a Rancho Santa Fe swimming pool is drawing attention for what it may signal about snake activity across Southern Cal...